Yellow Jacket  2 Roll Pullers - Bantam 4" wide and 12" wide floor model

Pictured: Yellow Jacket Bantam 2 Roll Puller (left) and water trough (right)
The Wayne Yellow Jacket Bantam 2 Roll Puller and 12" wide floor model two roll puller are ideal for:

• pulling tubing, rod, tape, strand, strip, and other products
• Laboratory testing
• Research and development
• Education and training
• Quality control
• Working with very small batches

• Air open/close nip rolls for easy thread up and emergency opening
• Compact table top design for Bantam and floor design for 12" wide model
• Electronic speed adjustment
• Neoprene covered rolls
• Standard 3" diameter X 4" wide rolls on Bantam width Cantilever (open end) design
• Standard 5" diameter X 12" wide rolls on Floor Model with both sides supported
• Guide rollers
• Emergency stop button opens rolls

All types of extrusions including tubing, rod, tape, strand, strip, and other products are easily pulled by the Wayne Yellow Jacket 2 Roll Puller. This universal capability is important in research labs where you never know what will have to be done next!

Air open/close nip rolls are a unique feature of the pullers. Many small pullers do not have air operated nips. These nips are easy to work with because they open and close with a flip of a switch making threading up the rolls easy! The other reason to have air operated rolls is so that they can easily be opened during an emergency by pressing the emergency stop switch.

Variable speed drive system is direct drive. No belts, chains or sheaves are used which is a major benefit to users. This avoids "cordal action" which can cause defects in the surface of the extrudate each time a chain link or belt tooth comes around.

Compact design allows you to fit the puller in a small space.

Leveling pads with adjustable height are standard with the Wayne Yellow Jacket Bantam 2 Roll Puller.

Back to the Wayne Home Page